A6 Pro Serial GPRS GSM Module Core Development Board

This is a professional version serial GSM / GPRS core development board based on the GPRS A6 module. It supports a dual-band GSM/GPRS network, available for GPRS and SMS message data remote transmission.

The board features a compact size and low current consumption. With the power power-saving technique, the current consumption is as low as 3mA in sleep mode.

It communicates with the microcontroller via the UART port and supports commands including GSM 07.07, GSM 07.05, and Ai-Thinker-enhanced AT Commands.

Caution: Use a resistor divider circuit before interfacing it with Arduino to avoid damage to the module.

Development Board Features :

• Working frequency: quad-band network, 850 / 900 / 1800 / 1900MHz
• Working voltage: 4.8-9VDC(On-board voltage regulator circuit supply power for A6 module)
• Working Current: maximum of 2A
• Sleep Current: 5mA
• Onboard Micro SIM card holder, you can install a Micro SIM card
• Onboard Micro USB interface for external power supply
• Communication Interface: TTL serial port / RS232 serial port
• Baud rate: 115200bps and it can also be set by AT command.
• Interface logic voltage: 3.3V
• Make and answer phone calls using a headset and electret microphone.
• Send and receive SMS messages.
• Send and receive GPRS data (TCP/IP, HTTP, etc.)
• Be used to test the Ai-Thinker GPRS A6 module
• Pin pitch: 2.54mm
• Onboard antenna interface: SMA and IPX

Antenna Features :

• Suitable for SIM800L GSM modules / for Arduino SIM900 GPRS Shield
• Working voltage: 4.8-9VDC(On-board voltage regulator circuit supply power for A6 module)
• Antenna gain: +2.0 ± 0.7 dBi @ 880 MHz, +2.0 ± 0.7 dBi @ 1800 MHz
• S.W.R <= 2.0 @ 2100 MHz ~ 2500 MHz
• Output Impedance: 50 Ohm
• Antenna interface: SMA

Package Includes :

1 x A6 Pro Serial GPRS GSM Module Core Development Board.